You hare here: Halon Bank / Service & Product / Fire Protection / DETECT fire / Fire Detection Systems

DETECT fire
Fire Detection Systems
Installation & Service
Fire Alarm Monitoring

 

 

 

 

 

 

 

 

 

 

 

 

 

Infra-Red BeamMaster-H Smoke Detector

Application
The Halon Bank BeamMaster-H Smoke Detector is designed for detection of smoke in large spaces such as halls, warehouses, museums, theatres etc., where point detection is impractical or more costly. The unit detects smoke linearly over the protected range enabling early detection before the fire spreads.

Operation
The emitter projects a near Infra-red beam which is detected by the receiver. The beam is pulsed to reduce the overall current consumption and improve the noise rejection characteristics. Powered directly from the Zonemaster conventional zone without the need for an external supply, when the zone is reset, the detector is automatically reset.

The emitter and receiver are synchronised via a direct 2 wire link which also supplies power to the emitter. All other field wiring is connected to the interface on the receiver. If smoke obscures the beam the receiver detects this and indicates a fire. Any gradual reduction in received light through environmental contamination is automatically compensated for within the detector.

In normal operation two status LEDs indicate a fire or fault condition, these are viewed through a unique lens that allows good visibility from any viewing angle particularly from beneath the unit. An output is also provided from the receiver for a remote fire indication.

The unit indicates a fault on the zone under the following conditions:

  • Compensation limit exceeded

  • Total Obscuration of Beam (Under this condition a fire signal will also be generated following a pre-defined time delay.)

  • Receiver cover left open

  • Receiver unit removed from zone

The BeamMaster-H can easily be connected to Halon Bank Controlmaster analogue systems by use of the Fireseeker Zone Interfaces. This enables the BeamMaster-H to be loop powered and reset from the loop when the user operates system reset from the fire control panel.


  

Also in this Section

Halon Bank - Experts in fire detection and suppression
Halon Bank can design, install, maintain and monitor fire systems using the latest technologies.

Fireseeker ZA Conventional Fire Detectors
The Fireseeker ZA range of conventional fire detectors are compatible with Halon Bank Zonemaster fire control panels. Each detector has been designed to provide an aesthetically pleasing modern

Zonemaster 200 Conventional Fire Control Equipment
The Zonemaster 200 range of advanced conventional fire alarm panels provide a unique and cost effective method of fire protection control.

Halon Bank Fireseeker Linear Heat Detection
Linear Heat Detection (LHD) cable systems provide a flexible durable and cost effective form of fire detection.

Controlmaster 100 Analogue Addressable Fire Alarm Control Panel
The Halon Bank Controlmaster 100 utilises the latest in analogue addressable fire alarm technology to provide a high quality flexible fire detection system.

Fireseeker CHX Intelligent Analogue Addressable Fire Detectors
The Fireseeker CHX range of intelligent analogue addressable devices are compatible with the Halon Bank Controlmaster range of fire control panels.

Atmosfire High Sensitivity Smoke Detection
The Atmosfire system provides extremely rapid detection of smoke in a wide range of environments.

        
About Halon Bank Legal Notices  -  Privacy Policy  -  Terms & Conditions  - Feedback